Objectives
Document the design, configuration, and testing of a small LAN.

Guidelines
This project is to be done individually. The overall objective is to document the design, configuration, and testing of a small network (LAN).

Overall instructions:
Create a Word document that includes a network diagram, a set of configuration listings, a selection of diagnostic and discovery commands, and a short written summary answering the questions listed below. Be sure to verify spelling.
Specific directions:
1. Create a cover sheet to identify, the class, the instructor’s name, and the submission date. This is page one of your project.
2. Use Visio to draw a small Local Area Network that consists of one router with two interfaces, two switches, and two PCs basically in this layout: PC1 -> Switch1 -> Router <- Switch2 <- PC2. Copy and paste your diagram on to the second page of your Word document. 3. Beginning with page three, write out the full configuration of ALL of the devices in your network to include two IPv4 subnets with the appropriate IP addresses, subnet masks, default gateways, and VLAN1 addresses. Include names for the devices and provide secure passwords at all levels of the network appliances. Include SSH on the router. 4. On a new, separate page, write out the full command line syntax to (1) save the configurations; (2) verify connectivity from one PC through the network to the other PC (use two different commands to do this); (3) display the saved configuration of the devices; and (4) display the routing table. DO NOT USE THE AUTOMATED SETUP SYNTAX FOR ANY OF THIS! 5. On your last page, answer the following questions: What part of this project was the most difficult and why? Do you feel more confident in your ability to actually build this kind of a network having completed this project? Why or why not? Answer Use Visio to draw a small Local Area Network that consists of one router with two interfaces, two switches, and two PCs basically in this layout Beginning with page three, write out the full configuration of ALL of the devices in your network to include two IPv4 subnets with the appropriate IP addresses, subnet masks, default gateways, and VLAN1 addresses. Include names for the devices and provide secure passwords at all levels of the network appliances. Include SSH on the router. The table below illustrates a full configuration of the devices in the proposed network. Destination of device Host Name/Interface IP Address Fa 0/0 VLAN 1 IP Address Subnet Mask IP Address S0/0/0 Subnet Mask Default Gateway Username Password PC1 Host.1 192.168.1.1.0 255.254.255.0

WeCreativez WhatsApp Support
Stuck with your assignment? When is it due? Chat with us.
👋 Hi, how can I help?